topic Re: Joint conflict - tutorial file in Fusion Design, Validate & Document Forum

Joint conflict - tutorial file

terryB2PX7 — Sun, 28 Jan 2018 03:31:14 GMT

Connecting crank arm to gear results in error:

Warning: Rev77
Compute Failed

Some positions cannot be resolved due to joint conflicts

Since this is a tutorial file, I am surprised to see an error.

Any suggestions?

davebYYPCU — Sun, 28 Jan 2018 10:40:59 GMT

Double check your selections, have you copied the tutorial?

Sounds like the crankrod is being asked to change height,

The tutorial selection under the crankrod, was the bottom of the orange bush,

No, you should not be getting an error if all the file is the same as the tutorial.

If you export the file, and attach it, we can answer with your data.

Might help...

terryB2PX7 — Mon, 29 Jan 2018 04:54:44 GMT

Attached is my version of the tutorial file with joint issue.

terryB2PX7 — Mon, 29 Jan 2018 05:05:19 GMT

Found that gear pin was positioned 0.2mm high

davebYYPCU — Mon, 29 Jan 2018 05:08:03 GMT

and all is good, or still getting the error?