Combine Cut Function trouble

Anonymous — Sat, 10 Feb 2018 23:04:21 GMT

Working on beveling a knife. I drew the wire frame of the bevel shape that I wanted then used the patch function and boundary/fill to create a solid to use as a cutting tool for the combine cut function. The two rear bevel sections this process worked out well and gave the desired results. Used the same steps to create the cut tool for the tip but am having trouble executing the combine cut function and not sure why or how to correct to make it work. Guidance appreciated. Previous designs I used the sweep to create bevel cut tools. This bevel is more complicated due to the combination of hollow and flat grinds and I could not get any satisfactory results from the sweep. If you have a better workflow than those I have described using I would be glad to hear them.

Screencast shows the attempt to cut the blank using the tool shape.

Re: Combine Cut Function trouble

jeff_strater — Sun, 11 Feb 2018 00:50:22 GMT

@Anonymous,

Your screencast didn't make it to the post. Can you try again (even a link to it would be good). Also, posting the model itself is the best way to get help, so if you can follow the directions here: How-to-share-a-Fusion-360-design.html, and choose one of those methods to share your design here.

Jeff

topic Re: Combine Cut Function trouble in Fusion Design, Validate & Document Forum

Combine Cut Function trouble

Re: Combine Cut Function trouble