topic Re: Problems sculpting a cylindrical body in Fusion Design, Validate & Document Forum

Problems sculpting a cylindrical body

Anonymous — Tue, 20 Feb 2018 11:55:40 GMT

Hi,

I am new to Fusion 360 .Iam tring to design a car tire and i hanve to admit this is a great tool. The problem is that whenever i select the edges and reduce the cicumference of one side of the cylinder the whole body undergoes changes to give me a conical look ,but that's not what i want .i want the edge to trace a face whenever i reduce the circumference .

iam i missing some sort of key or commmand here ?

can someone please help me out?

Re: Problems sculpting a cylindrical body

chrisplyler — Tue, 20 Feb 2018 16:05:12 GMT

You want the edge to "trace a face?" What does "trace a face" mean?

Re: Problems sculpting a cylindrical body

SaeedHamza — Tue, 20 Feb 2018 16:47:55 GMT

I believe what you're looking for is the alt key

When you edit the form, if you want to add a face when you make your move, you need to move while holding the alt key, so that a new face or faces according to your selection is added and that will prevent the whole body to be affected

Re: Problems sculpting a cylindrical body

Anonymous — Fri, 23 Feb 2018 15:48:13 GMT

Hii @Anonymous

Thanks for Posting your problem in Autodesk Forum.

To Solve that Condition You Should use add face commands for don't disturb other faces.

For add Face You should use ALT Key + Edit Form Command and you drag arrow according to need your direction of faces.

Best Regards

Anil kumar

(Student Expert)