topic Re: joints and motion study in Fusion Design, Validate & Document Forum

joints and motion study

Anonymous — Sun, 25 Mar 2018 09:43:15 GMT

Hi,

I'm working on yoke project and have to determine the angle of free movement.

I have problem to design model to move in two dimensions.

I will appreciate any help.

Thanks

Marcin

Re: joints and motion study

lucasliraAU — Sun, 25 Mar 2018 17:38:25 GMT

Hello!

I have been analyzing your file and found placements that were not compatible with the necessary displacement, I made some changes within your file I will leave attached here in this post so you can do your analysis.

I created a new study of movement the following is the result:

I believe these steps can help you in your work, good luck!

Did you find this answer helpful? If so, please use the Accept as Solution or Kudos button below.

Re: joints and motion study

lucasliraAU — Sun, 25 Mar 2018 17:41:25 GMT

Follows the movements of the mechanical components

Re: joints and motion study

lucasliraAU — Sun, 25 Mar 2018 17:56:40 GMT

Re: joints and motion study

Anonymous — Sun, 25 Mar 2018 18:30:33 GMT

Hi Lucas,

Thanks for your time to look at it.

After some errors I got want I wanted I think. Because I don't have so much experience I don't know if my approach is correct.

The idea is to check if the model with this dimension will work within specified angle.

The question is how can I easy change the angles of the yokes to see when both part start to collide to each others.

Marcin

https://knowledge.autodesk.com/community/screencast/12168b81-4c93-4f13-abd6-128e753a8cb0

Re: joints and motion study

lucasliraAU — Mon, 26 Mar 2018 10:17:14 GMT

Hello @Anonymous

To observe the interferences you can edit the point of rotation at the desired angle and thus perform the interference analysis between the components follows the display in the image.

I hope this can help you in your work!

Greetings.

Re: joints and motion study

Anonymous — Mon, 02 Apr 2018 09:35:55 GMT

thanks lucas, it works great