topic How to fix Reassociation error/message in Fusion Design, Validate & Document Forum

How to fix Reassociation error/message

r.chandraQ38SV — Wed, 24 Jul 2024 04:09:29 GMT

Hi,

I am trying to show that the centers of three essentric circles all bound by the larger(st) circle are in line.

Am doing this by drawing a straight line of the 2d drawing version, using the sketch feature (on the 2d drawing) along all 3 centers.

The best way to show the position of the centers relative to the larger (main circle, oir the circle within which the other circles are) is to show the angle between the line through the centers and the horizontal center line.

However I am getting a yellow triangle, which I need to get rid of.

Hope I am making sense.

I have tried to reassociate the lines, but no luck.

See below screenshot.

Re: How to fix Reassociation error/message

Fabbunny69 — Wed, 24 Jul 2024 08:21:21 GMT

Hi, I just tried to replicate what you are showing(estimated some positions, etc) and all is fine.

If you can't reassociate in the drawing, could the centerline through the eccentric holes have moved in your sketch?

Re: How to fix Reassociation error/message

r.chandraQ38SV — Wed, 24 Jul 2024 08:42:40 GMT

Thank you.

I tried your solution and it worked fine.

Thanks again