topic Re: Is collision detection during rotational simulation possible? in Fusion Design, Validate & Document Forum

Is collision detection during rotational simulation possible?

rduh_rtengineering — Thu, 01 Aug 2024 13:53:55 GMT

Hello,

I'm wondering if there's a way to simulate if a collision will occur or not.

I'm trying to rotate a rectangle around a centre ~100mm away, and see if it will collide with a triangle near the centre that I can change the positioning and size of.

I'm not even sure where to start, as I cannot even get a rotation to occur in a simple 2 component design when using simulation.

Thank you

Re: Is collision detection during rotational simulation possible?

jhackney1972 — Thu, 01 Aug 2024 14:27:41 GMT

I know the topic titles are different but this is the same question posted on the Fusion Support Forum. Please do not double post.

Re: Is collision detection during rotational simulation possible?

rduh_rtengineering — Thu, 01 Aug 2024 14:51:05 GMT

Sorry, I realised I had posted to the wrong category, so asked for the other one to be removed and posted it again in a more suitable category

Re: Is collision detection during rotational simulation possible?

etfrench — Thu, 01 Aug 2024 17:38:37 GMT

Instead of simulating it, rotate it using the new solid rotate, then check for interference.

p.s. Or just revolve the rectangle if it is in a sketch and not a solid.