topic Re: Sphere bug in Fusion Design, Validate & Document Forum

Sphere bug

SaeedHamza — Mon, 08 Oct 2018 21:25:07 GMT

Another strange bug I encountered

I was working on a door joint when I tried to create a normal model environment sphere and faced an issue

The sphere is like a low poly mesh although it's a BRep body … You'll also notice that the face of the piece is like a mesh although it's a BRep

I used the face of the joint piece as the plane of the sphere creation, and got a strange looking symbol at the center of a hole ( snapping symbol )

note : the door joint piece was imported into this design as a linked component

Re: Sphere bug

TrippyLighting — Mon, 08 Oct 2018 22:04:09 GMT

If you right-click on the body in the browser and select "Display detain control" and set it to Fixed/High, does that change anything ?

Re: Sphere bug

T2005 — Mon, 08 Oct 2018 23:47:03 GMT

Maybe if you were to break the link of the imported object it might make the bug go away.

Also I see that in the photo you took, the diameter is .002 mm. It could be a resolution error.

I hope this helps.

Best of luck,

T. K.

Re: Sphere bug

SaeedHamza — Tue, 09 Oct 2018 10:34:08 GMT

It increases the pixels a little bit, hardly recognizable

Re: Sphere bug

SaeedHamza — Tue, 09 Oct 2018 10:40:54 GMT

@T2005 no, breaking the link doesn't solve this

I noticed another thing regarding this bug

The bug occurs when I make a new sketch on the face of the imported piece ( door joint ), if the sketch or the sphere were made without selecting the piece as the creation plane, the bug doesn't occur

Here is a picture showing that even the sketch circle is looking low quality

And I have attached the file so that everyone can take a look

Re: Sphere bug

TrippyLighting — Tue, 09 Oct 2018 12:28:23 GMT

@James.Youmatz this is an interesting case.