topic Re: Sheet metal - Corner mitre not working?? in Fusion Design, Validate & Document Forum

Sheet metal - Corner mitre not working??

FabianaBBUSCK — Tue, 20 Aug 2024 03:58:31 GMT

Hi everyone!

A complete noobish over here.

I have to figure out how to fix the following:

It is probably because of the way I'm working, some operation must be wrong or in the wrong order.

After I create my top edge flanges, I create a sketch on the left side one to later extrude it and cut a piece of it, because I need the flange to be sloping.

The I proceed to create another flange starting from the recently cut edge (green) and also the other two not cut edges (yellow)

And the mitred corner does not happen 😞

My design methodology must be wrong, isn't it? Otherwise the software would be doing it by itself?

Or there could be steps to get it done I am not aware of.

Any help is much appreciated.

Cheers,

Fabi

Re: Sheet metal - Corner mitre not working??

Drewpan — Tue, 20 Aug 2024 06:34:38 GMT

Hi,

Have you tried a manual adjustment of the flat pattern to fix this? Trim out the bits that intersect on the flat pattern

and then refold it.

Cheers

Andrew

Re: Sheet metal - Corner mitre not working??

user015M86Y — Tue, 20 Aug 2024 09:44:43 GMT

Hi,

See attached my proposal

The corner mitre is not working because you cut one of the 3 bend flange make together

Adjust the mitre to 0.15*Thickness

I use the draft command to cut the flange and the 2 flange corner intersection

I got also the yellow warning for that flange but the flat pattern and unfold command work fine

Re: Sheet metal - Corner mitre not working??

FabianaBBUSCK — Wed, 21 Aug 2024 23:34:49 GMT

Hi Drewpan!
I have not tried this, but it sounds very logical now that you mention it.
I would just need to get the right angle on the side of the flat pattern, so when I re fld the piece, the mitre is correct.
Am I on the right track?

Cheers,
Fabi

Re: Sheet metal - Corner mitre not working??

FabianaBBUSCK — Wed, 21 Aug 2024 23:35:48 GMT

Thanks for that!
It actually works, and I am going to replicate the method on the other flange to make sure I got it right.

Cheers,
Fabi