topic Re: How make these Cuts on the Jar in Fusion Design, Validate & Document Forum

How make these Cuts on the Jar

hasanraxa0077 — Thu, 24 Apr 2025 05:28:57 GMT

I'm trying to make this candle jar in Fusion but can't get these get like this can anyone help me to how to do it thanks

Re: How make these Cuts on the Jar

davebYYPCU — Thu, 24 Apr 2025 07:43:03 GMT

I think I got it....

Might help...

Re: How make these Cuts on the Jar

hasanraxa0077 — Thu, 24 Apr 2025 08:14:50 GMT

Thanks for the reply, as you can see in the attach picture the cut goes to the top of the jar not in the middle can you help me increase that, i have tried my self but not getting it right

Re: How make these Cuts on the Jar

davebYYPCU — Thu, 24 Apr 2025 09:19:02 GMT

Old picture did not have this extra height.

2d picture makes it hard to see how it should be made.

Top edge is easy with Sweep, but the taper geometry for the floor is complicated and might help to get your model so I can assess what is actually needed.

Might help...

Re: How make these Cuts on the Jar

hasanraxa0077 — Thu, 24 Apr 2025 09:51:29 GMT

is this picture any good?

Re: How make these Cuts on the Jar

davebYYPCU — Thu, 24 Apr 2025 11:03:48 GMT

Ok for my first go, done that one.

Second one is having this change of curve

I am just asking about size of the jar, and this curve edge I could get that too, but I don't know what size to do it.

Re: How make these Cuts on the Jar

hasanraxa0077 — Thu, 24 Apr 2025 11:09:13 GMT

the size of the jar is 100mm in height and diameter of 70mm