topic Radius and copy in Fusion Design, Validate & Document Forum

Radius and copy

Anonymous — Sun, 24 Mar 2019 06:52:49 GMT

I have drawn a shaft with a keyway at one end. I now need to put a radius in the end of the keyway and then I need to copy the result to put in the same keyway in other locations. Any help would be most appreciated.

Brian

Re: Radius and copy

davebYYPCU — Sun, 24 Mar 2019 11:06:06 GMT

I presume you cut the key way with an Extrude along the shaft, resulting with square end plate. Fillet the two edges with half slot width.

you could also sketch a slot on the top view, with overhang and extrude to suitable depth.

would need more information about use for other models.

Might help....

Re: Radius and copy

Anonymous — Sun, 24 Mar 2019 11:56:41 GMT

Many thanks Dave, I'll get the hang of Fusion 360 eventually.
Brian