topic Help with 3D contour. in Fusion Design, Validate & Document Forum

Help with 3D contour.

justinnazzarese — Wed, 19 Jun 2019 10:33:15 GMT

Hello, im currently trying to make a front bumper for an RC car. I found a model for the front of the car. Right now the bumper is overlapping the model and if I were to print it, there would be a lot of cutting and trimming needed to get it to fit properly. Is there a way I can use the model of the front of the car to cut away the overlapping material of the bumper.

Re: Help with 3D contour.

TrippyLighting — Thu, 20 Jun 2019 20:55:48 GMT

The model you found looks like a proper quad mesh to me. That can be converted into a T-Spline and then into a surface.

That surface you can then use for trimming solid bodies, for example.

Re: Help with 3D contour.

justinnazzarese — Mon, 24 Jun 2019 01:43:54 GMT

I was about to convert it into a T-spline, but i cant convert it into a surface. When i try i get an error, i try to repair the body using the auto repair but nothing happens. Any tips?