Linear Pattern Problem

Anonymous — Mon, 18 Nov 2019 19:36:44 GMT

Unable to solve the linear pattern problem.

Any help appreciated in explaining how to do so.

dlw

Re: Linear Pattern Problem

tommVS2MB — Mon, 18 Nov 2019 22:53:43 GMT

Please, tell me more. I am not sure where the problem is

Tom Meyers

Anonymous — Mon, 18 Nov 2019 23:30:48 GMT

Thanks for replying.

The drawing did not post as expected. My fault.

The sander is 2 parts. Front for sanding, back for support of front and drive motor.

The front is attached through the back.

On the rear of the front is where the sanding plane and its supports have screws to make one assembly.

The problem is the linear pattern did not work properly due to not me knowing enough.

There is one hole drilled at the bottom and needs to 2 more above it and these three copied to the other side.

I tried and tried. Watched tutorials. Simply do not understand the error message in the time line regarding the problem.

dlw