topic Re: Fit an entire part into a drawing in Fusion Design, Validate & Document Forum

Fit an entire part into a drawing

Anonymous — Wed, 08 Apr 2020 10:21:48 GMT

Hello,

I'm trying to fit a 1300 mm long knife onto an A4 page at a reasonable scale (so you can see sufficient detail), on older software you're able to split the knife in half to fit it into an A4 sheet, is there any way to replicate this on fusion 360?

I've attached two images, one of the old drawing (which is split in half) and one of the new model which needs to be put onto a drawing. Any advise would help.

Thanks

Re: Fit an entire part into a drawing

avinash.patilRTX4R — Thu, 09 Apr 2020 02:28:43 GMT

Hi @Anonymous ,

Thanks for raising this issue on Autodesk community forum.

I have not found any attachment with this post as you mentioned. Please attach the images,

Or please mentioned where I can see those.

Waiting for your reply,

Thanks,

Re: Fit an entire part into a drawing

Anonymous — Thu, 09 Apr 2020 07:12:45 GMT

Sorry, here are the images.

Re: Fit an entire part into a drawing

Anonymous — Tue, 14 Apr 2020 12:34:30 GMT

Hi did you look at the linked images?

Re: Fit an entire part into a drawing

g-andresen — Tue, 14 Apr 2020 13:39:20 GMT

Hi,

this tool "broken view" isn´t available yet.

Roadmap

günther

Re: Fit an entire part into a drawing

laughingcreek — Wed, 15 Apr 2020 19:11:20 GMT

you can sorta fake it by using detail views. you put the main view off to the side off the sheet, and put 2 detail views on the page.