topic Re: Help on drawing Vent Pod in Fusion Design, Validate & Document Forum

Help on drawing Vent Pod

Anonymous — Sat, 25 Apr 2020 13:10:33 GMT

Hello, I'm a casual user of Fusion 360.

I'm portuguese and a friend send me a .stl file of a vent pod for my Ford Mustang, but i need to change de dimensions of the circles for 3D print, and i dont have the original file and dont know very well how to use Fusion 360.

Can someone give a hand on how to redraw de vent pod plz.

I attach the .stl file of the vent Pod.

Thanks,

Ricardo Cabouco

Re: Help on drawing Vent Pod

TheCADWhisperer — Sat, 25 Apr 2020 13:22:54 GMT

@Anonymous wrote:
....dont know very well how to use Fusion 360.

Fortunately the geometry is very simple and this will make a good learning exercise for a beginner.

Use the stl only as reference and recreate the part.

Ask questions as you go. I recommend that you Attach your *.f3d after completion of Sketch1 and each step that you make.

Re: Help on drawing Vent Pod

Anonymous — Sat, 25 Apr 2020 13:32:41 GMT

Thanks for aswer me i actually made 2 parts of de design but i dont know how to make the inside circle with the legs attach to outer circle and make it with inclination.

Re: Help on drawing Vent Pod

TheCADWhisperer — Sat, 25 Apr 2020 13:42:52 GMT

Keep trying while I work up a possible "solution" - you should be able to get this one.

~~Tip: Forget about the inclination for now - that will be easy to take care of in final step.~~

Re: Help on drawing Vent Pod

TheCADWhisperer — Sat, 25 Apr 2020 20:26:14 GMT

You can edit the sketch dimensions in the Attached as needed.

Re: Help on drawing Vent Pod

Anonymous — Sat, 25 Apr 2020 22:04:42 GMT

Thanks a lot. Huge help.