Extracting/Creating lines form a model

z.alexander616 — Mon, 25 May 2020 19:56:13 GMT

Hi guys,

I have a question about creating lines to follow the radius and I will do my best to word this. (Screenshots attached)

One image you will see a line that follows thru the main groove, which is what I need. I was about to create that with using the center of the body that I used to create the groove in the first place.

The real question is to get lines that work across the radius (2nd image with radius selected) that run up and down.

In the 3rd image there are 2 edges selected, one on each side of the radius. I basically want the lines in that direction that wrap around the radius, spaced 0.004 apart or so. The spacing shouldn't be an issue if I had a good approach to get the lines.

Any help is appreciated!

Re: Extracting/Creating lines form a model

g-andresen — Mon, 25 May 2020 20:35:32 GMT

Hi,

split face is your friend!

split face

günther

Re: Extracting/Creating lines form a model

z.alexander616 — Tue, 26 May 2020 03:44:29 GMT

I think this is going to work for what I need! Thank you very much!

topic Re: Extracting/Creating lines form a model in Fusion Design, Validate & Document Forum

Extracting/Creating lines form a model

Re: Extracting/Creating lines form a model

Re: Extracting/Creating lines form a model