https://forums.autodesk.com/t5/fusion-design-validate-document/flat-pattern-not-able-to-select-face/m-p/9602788#M107803 <P>So I have a very basic assembly where the base is essentially a bent piece of sheet metal and there is a gusset.</P><P>The base itself in the assembly, will not form a flat pattern because when I try to select the "stationary face" it simply won't let me use any of the faces on any of the components to make such a flat pattern. I have done this before with other assemblies and haven't had an issue, this is the first time.&nbsp;</P> Fri, 26 Jun 2020 03:31:10 GMT Anonymous 2020-06-26T03:31:10Z https://forums.autodesk.com/t5/fusion-design-validate-document/flat-pattern-not-able-to-select-face/m-p/9602788#M107803 <P>So I have a very basic assembly where the base is essentially a bent piece of sheet metal and there is a gusset.</P><P>The base itself in the assembly, will not form a flat pattern because when I try to select the "stationary face" it simply won't let me use any of the faces on any of the components to make such a flat pattern. I have done this before with other assemblies and haven't had an issue, this is the first time.&nbsp;</P> Fri, 26 Jun 2020 03:31:10 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/flat-pattern-not-able-to-select-face/m-p/9602788#M107803 Anonymous 2020-06-26T03:31:10Z https://forums.autodesk.com/t5/fusion-design-validate-document/flat-pattern-not-able-to-select-face/m-p/9606733#M107804 <P>Looks like, if you go back to the original assembly the drawing is taken from, you can right click on the component you want flat-patterned, create drawing, and input it into the drawing and sheet you'd like to insert it into. If that makes sense - provided the component has been flat-patterned in the model.</P><P>&nbsp;</P><P>JUST in case anyone else runs into this problem.</P> Mon, 29 Jun 2020 02:26:59 GMT https://forums.autodesk.com/t5/fusion-design-validate-document/flat-pattern-not-able-to-select-face/m-p/9606733#M107804 Anonymous 2020-06-29T02:26:59Z