topic Re: Why does the edge not show? in Fusion Design, Validate & Document Forum

Why does the edge not show?

lemelman — Wed, 01 Jul 2020 08:26:10 GMT

I used Section Analysis to check clearances and was a little surprised to notice a small part of the edge line was missing. It's neither a problem nor a concern, but it is a puzzle. I can't think of a reason for it, can you?

Re: Why does the edge not show?

MoshiurRashid — Wed, 01 Jul 2020 08:40:42 GMT

Thanks for posting. Can you please share the file here with the section applied?
It will help us to detect the problem

File> Export> f3d

Re: Why does the edge not show?

lemelman — Wed, 01 Jul 2020 09:16:28 GMT

Unfortunately, my internet went down before I could save anything, and when it came up I had to restart Fusion. Strangely, when displaying a similar X-section, that particular edge is present, but 2 others are missing.

Here's a screenshot, and the file.

Re: Why does the edge not show?

TrippyLighting — Wed, 01 Jul 2020 10:38:57 GMT

This is simply a viewport rendering artifact and has been reported before.

There's nothing wrong with your model that would cause this.

Re: Why does the edge not show?

lemelman — Wed, 01 Jul 2020 11:09:43 GMT

I didn't think it was a model defect; I was just curious as to what it was.

Re: Why does the edge not show?

TrippyLighting — Thu, 02 Jul 2020 12:14:32 GMT

OK. Can you please click the "Accept solution" button under a reply so we can close this thread?