topic Re: wait idle until to a queue in the 3D Model in FlexSim Forum

wait idle until to a queue in the 3D Model

savannah_b — Wed, 02 Dec 2020 12:50:41 GMT

[ FlexSim 20.0.9 ]

In my 3D Model there are 320 objects released each day but they get broken into batches that are defined by the capacity of another process (120). That leaves a batch that is only 80 objects. Is there a way in 3D Model to do a "Max Idle Timer" like there is in Process model?

I currently have it using the only 3D Model option in queue: Max Wait Time, but that means it has to wait for a full batch to be completed before sending -which it is not- and that creates an inaccurate run time.

Ideally, the queue would wait until it had a batch of 80 and then start a timer but I wasn't sure how to do that either.

Any suggestions are appreciated.

Re: wait idle until to a queue in the 3D Model

jonathan_s3 — Wed, 02 Dec 2020 19:27:10 GMT

Without looking at your model it would be difficult to determine a solution but you may look at the objects idle state timer in the model tree. You may be able to determine a way to monitor that then.

Re: wait idle until to a queue in the 3D Model

jason_lightfoot_adsk — Thu, 03 Dec 2020 14:52:44 GMT

You can send a delayed message to the queue when the content reaches 80 - do that on the entry trigger.

Then in the message trigger you could perform the actions you require - releasing flowitems to specific ports etc..based on the conditions when it fires.

Re: wait idle until to a queue in the 3D Model

Ben_WilsonADSK — Tue, 08 Dec 2020 15:00:00 GMT

Hi @Savannah, was jason.lightfoot's or Jonathan's answer helpful? If so, please click the red "Accept" button on one of their answers. Or if you still have questions, add a comment and we'll continue the conversation.

If we haven't heard back from you within 3 business days we'll auto-accept an answer, but you can always unaccept and comment back to reopen your question.

Re: wait idle until to a queue in the 3D Model

savannah_b — Thu, 10 Dec 2020 12:39:29 GMT

Is there a way to have the message pull a specific batch number depending on the day?

Re: wait idle until to a queue in the 3D Model

jason_lightfoot_adsk — Thu, 10 Dec 2020 17:51:19 GMT

The message could set a label which is then used by the pull requirement to only pull a certain batch number. Without seeing exactly what you're trying to do, our answers can only roughly guide you.