topic Re: Model crashing in FlexSim Forum

Model crashing

maria_a31 — Mon, 18 Jul 2022 14:10:48 GMT

[ FlexSim 21.1.5 ]

Hello everyone! I have a problem with the attached model. When i press the start button it does not load all the pallets in the racks and after a second the model crashed and closes. I have run it in several computers with very good specs so i can not understand why that happens.

ASRS.fsm

Re: Model crashing

jason_lightfoot_adsk — Mon, 18 Jul 2022 14:26:05 GMT

Is it that they're created at the other end of the rack? Check the bay progression is the correct X sign.

Attached is a version that will give you an errors message telling you that Rack202 receives a pallet which was not assigned a slot. So check the custom code that is handling the slot assignment strategy.

asrs.fsm

Are you meant to have duplicate entries in the Inventories table:

The above slots have two pallets listed for the same slot (which may/not be okay)

Re: Model crashing

maria_a31 — Mon, 18 Jul 2022 15:24:40 GMT

I fixed the X sings in the racks so now the palletsare not created at the end of the racks.

After that i could not make any changes in the code because the model started crashing again and now it doesn't even open.

Re: Model crashing

moehlmann_fe — Tue, 19 Jul 2022 06:16:27 GMT

Bay 1 only has two slots in each rack, yet items are assigned to a third slot in the inventory table.

The z-direction of the levels is also wrong on one of the racks in the middle. This causes some items to be assigned to the non-storable slots.

In the attached model I deleted the bay1/slot3 entries in the table and fixed the level and bay progression direction on the racks and it seems to work. I also reduced the number of boxes created on the pallets to reduce the load for testing purposes.

asrs_1.fsm

Re: Model crashing

maria_a31 — Wed, 20 Jul 2022 13:12:53 GMT

thank you @Felix Möhlmann i didnt notice the slot situation you were correct! thanks a lot