topic Re: Eagle to Fusion suggestions in EAGLE Forum

Eagle to Fusion suggestions

mario.brizida — Wed, 25 Jul 2018 15:25:46 GMT

Dear all;

When uploading a board to Fusion with correct definitions averythig goes right, but when generating a step file or igs, silkscreen and soldermask info is lost, and it's a very important info that should be transfered.

Another issue regards with silkscreen. Eagle only allows for silkscreen layer 25 for effect of Fusion trasfer, so when we use anoter layer we loose info or have a lots of work trasfering all info from any other layer to layer 25. If was allowed to use another layer than 25, would be easier to interchange info.

Do you think it's possible to implement these funcionalities on future versions of Eagle?

Thank you

Re: Eagle to Fusion suggestions

jorge_garcia — Tue, 31 Jul 2018 20:30:37 GMT

Hello @mario.brizida,

Thanks for participating on our forums. We have plans to support more layers in the ECAD-MCAD integration, however it may take some time before we get to that (as usual lots of other development going on).

Please let me know if there's anything else I can do for you.

Best Regards,

Re: Eagle to Fusion suggestions

yqliu — Wed, 01 Aug 2018 08:49:02 GMT

Hi @mario.brizida,

Thanks for your suggestion. If we support layers other than 25 for silkscreen, which layers will you use? It would be very helpful if you can share us how you will use the layers for different purpose.

Thanks,

Richard