topic Re: DRC - All Trace Widths Causing Errors in EAGLE Forum

DRC - All Trace Widths Causing Errors

tedj1 — Thu, 05 Sep 2019 13:03:50 GMT

Hi. I had a PCB that produced no errors in the DRC, until this morning when I opened it and all kinds of errors. Primarily, all traces are generating Width errors. Most all of mine are 10mil. The rest are 6 mil. I run DRC again. Under the Sizes tab, the Minimum Width is set at 6mil. I Apply and run the check. Yet, all of those Width errors still show. I can't understand what I must have changed, or what I'm doing wrong now and surely there's no Max Trace Width limit, although I did just upgrade to ver 9.5.0 from 9.4.2. Confused.

Re: DRC - All Trace Widths Causing Errors

rachaelATWH4 — Thu, 05 Sep 2019 14:23:50 GMT

@tedj1 wrote:

Under the Sizes tab, the Minimum Width is set at 6mil.

Also check in the net class setup that nothing has changed there as the net class will override the DRC defaults.

Best Regards,

Rachael

Re: DRC - All Trace Widths Causing Errors

tedj1 — Thu, 05 Sep 2019 17:31:05 GMT

Thanks. That was it.