topic Re: I'm looking to add a lisp command to a stretch in Dynamic Blocks Forum

I'm looking to add a lisp command to a stretch

cclawsonD6QHU — Mon, 11 Aug 2025 12:55:13 GMT

So I'm looking to add a Lisp command to my dynamic block that will update with a stretch command, for example said command will divide a line segment and add Drill holes to said line at equal intervals under 12" OC I believe I have a very rough working LISP Command for the vertical and horizontal lines, but I don't know how to associate that command with the stretch for the block. is that even possible?

I've attached both the block and the LISP.

Thanks.

Re: I'm looking to add a lisp command to a stretch

Libbya — Mon, 11 Aug 2025 13:30:16 GMT

The Dynamic Blocks forum focuses on the stock functions of dynamic blocks. For custom code, you will typically get much better responses from the LISP forum.

https://forums.autodesk.com/t5/visual-lisp-autolisp-and-general/bd-p/visual-lisp-autolisp-customization-forum-en

Re: I'm looking to add a lisp command to a stretch

cclawsonD6QHU — Mon, 11 Aug 2025 13:32:46 GMT

Right the code isn't what I was asking for it the inserting it into the block...

unless that is done in the code?

Re: I'm looking to add a lisp command to a stretch

Libbya — Mon, 11 Aug 2025 13:48:48 GMT

Yes, that would have to be done in the code. The only stock ways to control the parameters within a dynamic block are by adjusting the grips or entering values in properties.

Re: I'm looking to add a lisp command to a stretch

cclawsonD6QHU — Mon, 11 Aug 2025 13:50:45 GMT

thank you I will post there then.