topic Re: SIMPLE WALL SECTION DYNAMIC BLOCK in Dynamic Blocks Forum

SIMPLE WALL SECTION DYNAMIC BLOCK

nikm42Q9N — Thu, 03 Dec 2020 15:00:26 GMT

Hello,

I'm looking for a simple Dynamic block (or lisp) that would create a simple wall section

with options on stud thickness or cmu , air space, installation thickness, Drywall... etc

Either a dynamic block or a routine similar to the inputs on how Revit makes walls

This is for 2d wall sections only

Re: SIMPLE WALL SECTION DYNAMIC BLOCK

pendean — Thu, 03 Dec 2020 17:14:44 GMT

Why don't you post your 'simple' wall section and it's variations, lets see what you got and wish to convert into a single DynBlock.

Re: SIMPLE WALL SECTION DYNAMIC BLOCK

tim_crouse — Fri, 04 Dec 2020 16:06:45 GMT

Take a look in these files, you will see a dynamic block wall partition that may help you.

Best Regards

-Tim

Re: SIMPLE WALL SECTION DYNAMIC BLOCK

nikm42Q9N — Thu, 10 Dec 2020 21:44:41 GMT

Was able to take yours and "reverse engineer" what I wanted. thanks allot

Re: SIMPLE WALL SECTION DYNAMIC BLOCK

tim_crouse — Fri, 11 Dec 2020 10:31:34 GMT

f you made another wall type would you mind sharing it? Could always use another wall in my library.

If not I understand.

Thanks

-Tim C.

Re: SIMPLE WALL SECTION DYNAMIC BLOCK

Bamcosd — Fri, 06 Sep 2024 18:32:06 GMT

Good afternoon Tim, thank you so much for uploading your blocks they are a huge help to my learning. I have a question about your "Wall Partition Dynamic" block. You have the top track and insulation separated from the main body of the partition and I have to move the top track individually? Why is that? Just curious. Thanks again.