topic Re: ConditionalCutOrFill no applying subassemblies in Civil 3D Forum

ConditionalCutOrFill no applying subassemblies

fteixeiraR39AC — Tue, 10 Jan 2023 14:57:32 GMT

Hello,

I reading the help section of the ConditionalCutOrFill subassembly and it states that: "This subassembly automatically applies various subassemblies, such as generic links, widening, ditching, or daylighting subassemblies, to an assembly based on whether a cut or fill condition exists."

Civil3D is not applying the stated various subassembies, only the conditional cut or fill...

What is the issue?

Re: ConditionalCutOrFill no applying subassemblies

Matheus-Lima — Tue, 10 Jan 2023 23:18:57 GMT

Hi @fteixeiraR39AC, you need to add more subassemblies after the ConditionalCutOrFill. The conditional subassembly is used to check if it is a cut or fill section and it applies a first slope parameter.

For example, notice here one ConditionalCutOrFill with type parameter as CUT and another one with the type parameter as FILL, plus subassemblies after the conditional ones. So, below I have 4 subassemblies only for daylighting.

For example, from the help article:

The top left side ConditionalCutOrFill subassembly is configured to automatically add a Bench subassembly when Autodesk Civil 3D detects that the assembly is in a cut condition.

On the top left, ConditionalCutOrFill Subassembly (with type parameter as CUT) + Bench Subassembly = 2 subassemblies (and you can add more).

Hope it helps!

Re: ConditionalCutOrFill no applying subassemblies

Jeew-m — Wed, 11 Jan 2023 04:56:07 GMT

You can get more idea about the conditional cut and fill assembly from here.

Re: ConditionalCutOrFill no applying subassemblies

fteixeiraR39AC — Wed, 11 Jan 2023 09:03:41 GMT

Thank you for your reply!