topic Re: Alignment Report for Alignment with Negative Chainages in Civil 3D Forum

Alignment Report for Alignment with Negative Chainages

Yash.KatragaddaHTL8B — Tue, 27 Jun 2023 01:30:31 GMT

Hi, I am trying to get an Alignment report which has negative chainages at the start of alignment due to some last minutes changes and now when I select the Alignment to create the report a pop up message saying "Station Value is out of range" comes up.

Is there a work around to get Alignment report for the Alignment with negative chainages?

Thanks,

Yash

Re: Alignment Report for Alignment with Negative Chainages

ecfernandez — Tue, 27 Jun 2023 14:31:56 GMT

Hi @Yash.KatragaddaHTL8B, you can try creating a new alignment from existing alignment that covers the whole old alignment, covering both the negative and positive chainages. Then try again to create the report.

I hope this helps. Best regards!

Re: Alignment Report for Alignment with Negative Chainages

tcorey — Tue, 27 Jun 2023 18:09:42 GMT

Which specific report are you running? Horizontal Alignment Report works fine with negative stationing at the start.