topic Re: Plotting Time (Iterations) vs Temperature at Certain points of Model in CFD Forum

Plotting Time (Iterations) vs Temperature at Certain points of Model

Anonymous — Tue, 29 Sep 2015 03:47:04 GMT

Hi guys,

I am unsure if it is an obvious answer but I have had a good look around for a setting or option to plot the temperature of all iterations at certain points of my model. I am simulating the thermal performance of a simple house and looking to compare the temperature of various points around the model. I have looked all through the 'points' tool in the results tab but cannot find how to vary the iteration that the temperature value is being taken from.

If you need any more information please do not hesitate to ask.

Thanks for your time,

Jonathon

Re: Plotting Time (Iterations) vs Temperature at Certain points of Model

Jon.Wilde — Tue, 29 Sep 2015 08:45:45 GMT

Try a monitor point re-run. This will give you all the variables for every time step 🙂

Thanks,

Jon

Re: Plotting Time (Iterations) vs Temperature at Certain points of Model

Anonymous — Fri, 02 Oct 2015 03:45:17 GMT

Hi Jon,

Is there a way to do something similar with a surface? I am looking to get the Heat flux over time. I can use Wall Calculator but i am looking to obtain values for the entire simulation for analysis reason.

Thanks for your time,

Jonathon

Re: Plotting Time (Iterations) vs Temperature at Certain points of Model

Anonymous — Fri, 09 Oct 2015 16:25:58 GMT

I need the same thing and posted in idea station.

http://forums.autodesk.com/t5/cfd-ideastation/results-history-of-transient-simulation/idi-p/5770718

http://forums.autodesk.com/t5/cfd-general-discussion/bulk-values-in-transient-solution/m-p/5826009#M9180