https://forums.autodesk.com/t5/cfd-forum/heat-exchanger-material-flag/m-p/6816577#M16343 <P>Hi,<BR /><BR />Autodesk Knowledge says this note about heat exchanger materials:<BR /><BR /><STRONG>"Note: Use the Flag Manager to enable the flag called inlet_is_vol_flow_bc if the heat exchanger device must be positioned near a pressurized area"</STRONG><BR /><BR />But i can´t find this flag in the flag manager.<BR /><BR />Can someone show me the procedure to activate this flag?</P> Thu, 19 Jan 2017 15:53:05 GMT Anonymous 2017-01-19T15:53:05Z https://forums.autodesk.com/t5/cfd-forum/heat-exchanger-material-flag/m-p/6816577#M16343 <P>Hi,<BR /><BR />Autodesk Knowledge says this note about heat exchanger materials:<BR /><BR /><STRONG>"Note: Use the Flag Manager to enable the flag called inlet_is_vol_flow_bc if the heat exchanger device must be positioned near a pressurized area"</STRONG><BR /><BR />But i can´t find this flag in the flag manager.<BR /><BR />Can someone show me the procedure to activate this flag?</P> Thu, 19 Jan 2017 15:53:05 GMT https://forums.autodesk.com/t5/cfd-forum/heat-exchanger-material-flag/m-p/6816577#M16343 Anonymous 2017-01-19T15:53:05Z https://forums.autodesk.com/t5/cfd-forum/heat-exchanger-material-flag/m-p/6818975#M16344 <P>Just enter it manually, ignoring any error messages popping up. It should work then...</P> Fri, 20 Jan 2017 10:33:26 GMT https://forums.autodesk.com/t5/cfd-forum/heat-exchanger-material-flag/m-p/6818975#M16344 Anonymous 2017-01-20T10:33:26Z