topic Re: Cannot join polylines in AutoCAD for Mac Forum

Re: Cannot join polylines

Apex-Solutions — Mon, 03 Jul 2017 14:47:10 GMT

Just to confirm. You are not using AutoCAD LT 2015?

If this is the full AutoCAD, which I assume it is then please head over to this knowledge base to fix the issue where the AutoCAD Flatten command is listed as an unknown command. https://knowledge.autodesk.com/search-result/caas/sfdcarticles/sfdcarticles/Using-an-Express-Tools-command-in-AutoCAD-shows-unknown-command.html

Regards

Marnus van Staden

Technical consultant & Civil 3D support Specialist

Prokon Software Consultants

Re: Cannot join polylines

maxim_k — Tue, 04 Jul 2017 04:10:14 GMT

Hi Marnus,

For the moment there is no FLATTEN command in AutoCAD for Mac.
The article you referenced here is about AutoCAD for Windows, but here is AutoCAD for Mac Forum.

Maxim

Re: Cannot join polylines

Apex-Solutions — Tue, 04 Jul 2017 06:13:34 GMT

It would seem that the reply I posted was removed from the original poster...??

Regards

Marnus

Re: Cannot join polylines

Apex-Solutions — Tue, 04 Jul 2017 06:13:57 GMT

It would seem that the reply I posted was removed from the original poster?

Regards

Marnus

Re: Cannot join polylines

maxim_k — Tue, 04 Jul 2017 06:19:25 GMT

Yes, looks like OP deleted the original post at the time when you wrote the reply.

Maxim

Re: Cannot join polylines

Apex-Solutions — Tue, 04 Jul 2017 06:27:19 GMT

https://forums.autodesk.com/t5/nastran-in-cad-forum/cannot-join-polylines/m-p/7200572#M2045

Still there

Regards

Marnus van Staden

Technical consultant & Civil 3D support Specialist

Prokon Software Consultants

Re: Cannot join polylines

maxim_k — Tue, 04 Jul 2017 07:04:56 GMT

I see.
So you already answered OP's question there.

Maxim

Re: Cannot join polylines

Apex-Solutions — Tue, 04 Jul 2017 07:09:11 GMT

Found the answer this morning after you mentioned that the Flatten command does not exist in AutoCAD MAC.

Thanks.