https://forums.autodesk.com/t5/autocad-lt-forum/angular-dimensions/m-p/3200794#M75593 <P>thanks.</P><P>&nbsp;</P> Fri, 21 Oct 2011 17:40:18 GMT Anonymous 2011-10-21T17:40:18Z https://forums.autodesk.com/t5/autocad-lt-forum/angular-dimensions/m-p/3199298#M75589 <P>Is there any way possible to have an angular dimension to denote an angle of greater than 180degrees?</P> Thu, 20 Oct 2011 19:26:11 GMT https://forums.autodesk.com/t5/autocad-lt-forum/angular-dimensions/m-p/3199298#M75589 Anonymous 2011-10-20T19:26:11Z https://forums.autodesk.com/t5/autocad-lt-forum/angular-dimensions/m-p/3200458#M75590 <P>Are you using DIMANGULAR command? What the command line, you get an extra choice calle SPECIFY VERTEX, pick the angle vertex and follow the prompts to specify the other two points</P> Fri, 21 Oct 2011 14:30:42 GMT https://forums.autodesk.com/t5/autocad-lt-forum/angular-dimensions/m-p/3200458#M75590 pendean 2011-10-21T14:30:42Z https://forums.autodesk.com/t5/autocad-lt-forum/angular-dimensions/m-p/3200506#M75591 <P>yes, i am using DIMANGULAR.</P><P>&nbsp;</P><P>command line reads&nbsp; :select arc, circle, line or &lt;specify vertex&gt;</P><P>&nbsp;</P><P>specify vertex is all lower case and i'm not sure how to select it.</P> Fri, 21 Oct 2011 14:58:52 GMT https://forums.autodesk.com/t5/autocad-lt-forum/angular-dimensions/m-p/3200506#M75591 Anonymous 2011-10-21T14:58:52Z https://forums.autodesk.com/t5/autocad-lt-forum/angular-dimensions/m-p/3200670#M75592 <P>When presented with a single command suboption like that, there is nothing to type: simply hit &lt;enter&gt; to activate.</P> Fri, 21 Oct 2011 16:20:55 GMT https://forums.autodesk.com/t5/autocad-lt-forum/angular-dimensions/m-p/3200670#M75592 pendean 2011-10-21T16:20:55Z https://forums.autodesk.com/t5/autocad-lt-forum/angular-dimensions/m-p/3200794#M75593 <P>thanks.</P><P>&nbsp;</P> Fri, 21 Oct 2011 17:40:18 GMT https://forums.autodesk.com/t5/autocad-lt-forum/angular-dimensions/m-p/3200794#M75593 Anonymous 2011-10-21T17:40:18Z