topic Re: draw parallel lines in AutoCAD Forum

draw parallel lines

Anonymous — Thu, 29 Oct 2020 09:42:02 GMT

Hi I need to draw parallel lines to create for example a staircase. By using the parallel or offset command, I can make the parallel lines but the angle of rise of the lines cannot be altered. Is there a way where this can be changed?

parallel lines need to touch the line below.

\Pls give solution if possible.

Thanks

Gazaal

Betreff: draw parallel lines

cadffm — Thu, 29 Oct 2020 10:55:57 GMT

Command Copy

Re: draw parallel lines

vinodkl — Thu, 29 Oct 2020 11:29:05 GMT

Hi @gazaal_c

Try using "COPY" command with array🙂

Re: draw parallel lines

imadHabash — Thu, 29 Oct 2020 14:03:38 GMT

Hi,

I think that you're asking about drawing an isometric stair . click on below image and see how with ISODRAFT command you can do it. you can draw 2D isometric representations of 3D models .you can while drawing the stairs switch your direction by Ctrl+E . also you can draw a real 3d stair model by using 3d commands.

Re: draw parallel lines

imadHabash — Thu, 29 Oct 2020 14:23:32 GMT

click on below image to see how with EXTRUDE 3d command you can do a 3d solid stair . prepare your 3d polyline stair elevation in a proper angle then just extrude it .

Re: draw parallel lines

Kent1Cooper — Thu, 29 Oct 2020 14:35:58 GMT

@imadHabash wrote:

.... I think that you're asking about drawing an isometric stair . ....

I don't think so. See the caption under the image in Message 1. @Anonymous, can you clarify?