topic Re: Cannot hatch due to unenclosed boundary? in AutoCAD Forum

Cannot hatch due to unenclosed boundary?

htoolwepawk — Thu, 31 Oct 2024 00:14:13 GMT

Hi,

I am attempting to hatch this road, the boundaries in red, as i have done successfully to the road above it. However, i keep getting this message that the area is not enclosed however i have joined the two points using the endpoint in snap, so it should be closed? Autocad has highlighted the areas where the gaps are, and even in places where i am not trying to hatch, i have attempted to close them but its not working?

Re: Cannot hatch due to unenclosed boundary?

Tomislav.Golubovic — Thu, 31 Oct 2024 00:22:09 GMT

If you zoom right in to those red circles, are they definitely connected?

Re: Cannot hatch due to unenclosed boundary?

htoolwepawk — Thu, 31 Oct 2024 00:40:28 GMT

Hi, this is the closest i can zoom into it 😞

Re: Cannot hatch due to unenclosed boundary?

htoolwepawk — Thu, 31 Oct 2024 00:42:22 GMT

actually this si the closest i can get

Re: Cannot hatch due to unenclosed boundary?

Tomislav.Golubovic — Thu, 31 Oct 2024 01:25:20 GMT

Can you upload the file here?

Re: Cannot hatch due to unenclosed boundary?

htoolwepawk — Thu, 31 Oct 2024 01:28:51 GMT

okay, here is the drawing file

Re: Cannot hatch due to unenclosed boundary?

Tomislav.Golubovic — Thu, 31 Oct 2024 01:38:10 GMT

Mine works fine on my end.

Zoom out until you can see the whole thing you want to hatch, then click inside the area and it'll hatch.

Re: Cannot hatch due to unenclosed boundary?

htoolwepawk — Thu, 31 Oct 2024 01:45:11 GMT

It works! Thanks you're awesome