topic smoothening edges in a 3D model in AutoCAD Forum

smoothening edges in a 3D model

j.bongers — Wed, 30 Mar 2022 07:11:01 GMT

A want to remove this cut out and change the height at the end of this curve to 0, in order to smoothen my model.

I tried to sweep it, but nothing works.

The angle of the 2 faces stand in a 90 degrees angle opposite to eachother.

What is the best way to do this ?

J.Bongers

imadHabash — Wed, 30 Mar 2022 07:24:40 GMT

Hi,

Honestly i didn't catch your point enough .. But you can use PRESSPULL command that may help .

j.bongers — Wed, 30 Mar 2022 07:47:29 GMT

Presspull only stretches up the solid that is not what I was looking for.

I now try to fit in a solid which I create with Sweep > Scale, but that is a way to work around it I guess.

Also I am limited because I cannot sweep a region which extends over te center point of the sweep path.

j.bongers — Wed, 30 Mar 2022 08:01:17 GMT

When I substract solids from it I get the following

But the height loss is only 30% of the original height at the beginning.

There must be a better way to do this....

Jos.

j.bongers — Wed, 30 Mar 2022 12:06:55 GMT

Loft gives better results.

I had to figure out it myself this is the result