https://forums.autodesk.com/t5/autocad-forum/polar-array/m-p/5546603#M336813 <P>That is probably only a matter of display resolution -- I think you will find that it <EM>uses</EM> the angle you specify, even if it <EM>shows</EM> it rounded.&nbsp; Get into UNITS and set a higher degree of precision for angles.</P> Wed, 18 Mar 2015 14:50:49 GMT Kent1Cooper 2015-03-18T14:50:49Z https://forums.autodesk.com/t5/autocad-forum/polar-array/m-p/5546586#M336812 <P>Hi, I am trying to figure out if there is an option in the polar array that will not round up when I enter a degree. I am polar arraying a set of items and the distance between them is 32.73. When I enter this in the "between" under items, it automatically rounds it to 33 degrees. Is there any option to make it not do this?</P><P>Thank you in advance!</P> Wed, 18 Mar 2015 14:43:31 GMT https://forums.autodesk.com/t5/autocad-forum/polar-array/m-p/5546586#M336812 Anonymous 2015-03-18T14:43:31Z https://forums.autodesk.com/t5/autocad-forum/polar-array/m-p/5546603#M336813 <P>That is probably only a matter of display resolution -- I think you will find that it <EM>uses</EM> the angle you specify, even if it <EM>shows</EM> it rounded.&nbsp; Get into UNITS and set a higher degree of precision for angles.</P> Wed, 18 Mar 2015 14:50:49 GMT https://forums.autodesk.com/t5/autocad-forum/polar-array/m-p/5546603#M336813 Kent1Cooper 2015-03-18T14:50:49Z https://forums.autodesk.com/t5/autocad-forum/polar-array/m-p/5546627#M336814 <P>Your solution worked!Thank you!</P> Wed, 18 Mar 2015 14:57:48 GMT https://forums.autodesk.com/t5/autocad-forum/polar-array/m-p/5546627#M336814 Anonymous 2015-03-18T14:57:48Z