topic Re: Dragmode turns itself off in AutoCAD Forum

topic Re: Dragmode turns itself off in AutoCAD Forum https://forums.autodesk.com/t5/autocad-forum/dragmode-turns-itself-off/m-p/5654085#M328301 This is my history, the dragmode is turned off after a copy, i did not type any of that.  I used copy, this comes in as multiple by default and then excaped out of that comman when completed.  I then went onto the move command.    odd this.    Select object to offset or [Exit/Undo] <Exit>: Specify point on side to offset or [Exit/Multiple/Undo] <Exit>: Select object to offset or [Exit/Undo] <Exit>: Specify point on side to offset or [Exit/Multiple/Undo] <Exit>: Select object to offset or [Exit/Undo] <Exit>: *Cancel*   Command: Command: Command: *Cancel*   Command: Command: Command: _copy Select objects: Specify opposite corner: 0 found Select objects: Specify opposite corner: 1 found   Select objects: Specify opposite corner: 1 found, 2 total   Select objects: Specify opposite corner: 4 found (2 duplicate), 4 total   Select objects: Specify opposite corner: 2 found, 6 total   Select objects: Specify opposite corner: 2 found, 8 total   Select objects: 1 found, 9 total   Select objects: 1 found, 10 total   Select objects:   Current settings:  Copy mode = Multiple Specify base point or [Displacement/mOde] <Displacement>: Specify second point or [Array] <use first point as displacement>: Specify second point or [Array/Exit/Undo] <Exit>: *Cancel*   Command: Command: Command: dragmode Enter new value [ON/OFF/Auto] <Auto>: OFF   Command: Command: Command: _move Select objects: Specify opposite corner: 2 found Wed, 27 May 2015 18:40:52 GMT Rpunturi 2015-05-27T18:40:52Z