https://forums.autodesk.com/t5/autocad-forum/using-autocad-to-turn-grasshopper-generated-objects-into/m-p/5980586#M297072 <P>Alternatively - If I could skip grasshopper entirely&nbsp;and just convert the points generated in rhino into instances of the same block in AutoCAD, that would work!&nbsp;</P><P>&nbsp;</P> Fri, 08 Jan 2016 22:58:18 GMT Anonymous 2016-01-08T22:58:18Z https://forums.autodesk.com/t5/autocad-forum/using-autocad-to-turn-grasshopper-generated-objects-into/m-p/5980542#M297071 <P>Hello!&nbsp;</P><P>&nbsp;</P><P>I have been using grasshopper this morning for some basic parametric work. From a spread of points in Rhino, I generated small rectangles&nbsp;as curves (lines for those of you unfamiliar with Rhino). I need to make these squares into components, such that each square is an instance of the same component. However, Grasshopper does not allow me to generate these as components/blocks.&nbsp;</P><P>&nbsp;</P><P>Does anyone know how I could use AutoCAD to convert a large number of rectangles to instances of the same component? They are all the same size. A coworker of mine says it can be done but doesn't know how.&nbsp;</P><P>&nbsp;</P><P>Much thanks to anyone who can answer my quandry!&nbsp;</P><P>&nbsp;</P><P>BW</P> Fri, 08 Jan 2016 22:33:08 GMT https://forums.autodesk.com/t5/autocad-forum/using-autocad-to-turn-grasshopper-generated-objects-into/m-p/5980542#M297071 Anonymous 2016-01-08T22:33:08Z https://forums.autodesk.com/t5/autocad-forum/using-autocad-to-turn-grasshopper-generated-objects-into/m-p/5980586#M297072 <P>Alternatively - If I could skip grasshopper entirely&nbsp;and just convert the points generated in rhino into instances of the same block in AutoCAD, that would work!&nbsp;</P><P>&nbsp;</P> Fri, 08 Jan 2016 22:58:18 GMT https://forums.autodesk.com/t5/autocad-forum/using-autocad-to-turn-grasshopper-generated-objects-into/m-p/5980586#M297072 Anonymous 2016-01-08T22:58:18Z