topic Re: Extrude - object removed from selection set in AutoCAD Forum

Extrude - object removed from selection set

Anonymous — Fri, 08 Sep 2017 09:41:56 GMT

Hello,

SO I am having this problem that I cannot extrude petals of this flower. I created 1 of the petal into polyline (blue one) and it still gives me "object removed from selection set". Where could this problem be?

Re: Extrude - object removed from selection set

Alfred.NESWADBA — Fri, 08 Sep 2017 09:56:52 GMT

Hi,

>> it still gives me "object removed from selection set"

That is not all you get ... 😉

In most cases I have trouble with _EXTRUDE I try command _PRESSPULL if that can work with that geometry.

- alfred -

Re: Extrude - object removed from selection set

Anonymous — Fri, 08 Sep 2017 09:59:17 GMT

Yes, when I presspull, I get cannot extrude self interacting curve...

How do I fix this? 😞

Re: Extrude - object removed from selection set

parkr4st — Fri, 08 Sep 2017 10:07:05 GMT

moved the radial lines to a new layer RadialLines and hid it; set new layer to petals and used bpoly command. only one of your petals is closed and made a new petal. that will extrude fine.

it is in the attached drawing

you can extrude and arraypolar that item

there is/are problem(s) in the original line work someplace.

dave

Re: Extrude - object removed from selection set

Anonymous — Fri, 08 Sep 2017 10:19:52 GMT

But that pink petal extrudes only in net form for me, as if it wasnt closed boundary

Re: Extrude - object removed from selection set

parkr4st — Fri, 08 Sep 2017 10:48:27 GMT

EXTRUDE, MOde set to solid?

Re: Extrude - object removed from selection set

Anonymous — Fri, 08 Sep 2017 11:20:22 GMT

Ok, I have managed to extrude this one petal here, hut now I am having problems creating surface according to these pink splines... I need to create surface before using polar array... Any ideas?

I tried using networksrf command, but it requires two directions. Any ideas how I can define these two directions to make surface?

Re: Extrude - object removed from selection set

parkr4st — Fri, 08 Sep 2017 12:43:10 GMT

one way

draw arcs at each end of the petal and loft those with the center profile you provided. More cross sections can provide more detail.

dave

Re: Extrude - object removed from selection set

parkr4st — Fri, 08 Sep 2017 12:45:06 GMT

use this dwg, the other didn't save correctly:(

Re: Extrude - object removed from selection set

Anonymous — Fri, 08 Sep 2017 12:50:08 GMT

"with the center profile you provided" you mean that only cross section of two purple splines? 🙂 I see, i need to create more boundaries(arcs/splines) of this surface, for it to fit to the frame, correct? 🙂