topic Re: Superhatch Scale 1 appearing too small in AutoCAD Forum

Superhatch Scale 1 appearing too small

Anonymous — Mon, 03 Jun 2019 10:16:46 GMT

Hello,

I have this problem with superhatch: I use the command and everything works fine, but after some hours of using the DWG file with superhatch patterns within it, when I try to use superhatch again, the scale 1 appears too small and I am unable to fill a boundary with it, I click in the boundary and it's like nothing happens. Plus, it doesn't group de blocks anymore, even with Pickstyle at 1 and the group selection On.

I must be doing some kind of keyboard combination that causes this, don't know how though.

Does anyone knows how to fix this?

Thank You

Re: Superhatch Scale 1 appearing too small

imadHabash — Mon, 03 Jun 2019 10:32:18 GMT

Hi,

would you please attache here your CAD drawing sample for testing , SAVE AS your drawing as AutoCAD 2013 version type please ?

>> the scale 1 appears too small and I am unable to fill a boundary with it,

the question here is , does the hatch appear or not ? check if FILL is ON .

Command: FILL
Enter mode [ON/OFF] <ON>:

Re: Superhatch Scale 1 appearing too small

Anonymous — Mon, 03 Jun 2019 10:49:02 GMT

Hi,

I attached the file sample.

I have "FILL" On, it doesn't show at all after I select the boundary because the scale 1 is too small. I just figured out that if I put a scale higher, like 1000 it shows in a normal size. I think it might be a units problem. But i never changed the units.

The other problem, which I can't figure out, is with grouping the blocks, the superhatch stops being a group mid working on the file even if I have group selection on.

Thank you.