topic Re: I can't fillet. Shows failure while filleting in AutoCAD Forum

I can't fillet. Shows failure while filleting

Anonymous — Sun, 19 Jan 2020 16:51:18 GMT

Please can anyone assist me in getting the attached file filleted? I'm trying to design a logo for a watch store called watchmen. I can't seem to get it correctly. Any help would be greatly appreciated. And also any suggestions on the material I should apply.

Re: I can't fillet. Shows failure while filleting

parkr4st — Sun, 19 Jan 2020 19:11:34 GMT

radius? .5 doesn't work, .25 or .34 or.4 or .45 does work .495 doesn't

Re: I can't fillet. Shows failure while filleting

Anonymous — Sun, 19 Jan 2020 20:51:11 GMT

I've tried it too, it just doesn't work, some edges can be filleted, while others can't. And I don't know why. Can you try it if you can come up with something?

Re: I can't fillet. Shows failure while filleting

Alfred.NESWADBA — Sun, 19 Jan 2020 22:37:17 GMT

Hi,

I would not use SPLINES for the contour of this logo, recreate the contour with polylines and all will work better.

- alfred -

Re: I can't fillet. Shows failure while filleting

S.Faris — Mon, 20 Jan 2020 04:22:53 GMT

Please highlight the edges that can't be filleted so that it will be easy for us to understand what the issue might be . That will help us save a lot of time

Re: I can't fillet. Shows failure while filleting

imadHabash — Mon, 20 Jan 2020 09:52:52 GMT

it seems fine with me ... try FILLETEDGE command ( change radius option value ) . make your model orientation as shown below then active FILLETEDGE command and select edge corners then double enter .