topic Cross Reference Format Components vs Source/Destination in AutoCAD Electrical Forum

Cross Reference Format Components vs Source/Destination

NReichmanR6N4Y — Wed, 05 Mar 2025 22:30:39 GMT

How would I set up my cross-reference so that my components use the #S—#N format and my source and destination only use the #N format? The picture below is how I want it set up.

Right now, I need to take an extra step by changing the drawing properties, doing a Component Cross-reference update, changing the drawing properties again, and then doing an Update Signal Reference.

I want to avoid doing this step.

Re: Cross Reference Format Components vs Source/Destination

jed43243 — Wed, 30 Jul 2025 18:48:28 GMT

Did you ever figure this out? I am struggling with the same issue.

Re: Cross Reference Format Components vs Source/Destination

NReichmanR6N4Y — Wed, 30 Jul 2025 18:56:18 GMT

No, I wasn't able to figure it out.

Re: Cross Reference Format Components vs Source/Destination

arshdeepsingh404 — Sat, 02 Aug 2025 02:09:25 GMT

Hi @NReichmanR6N4Y @jed43243

If you don't want to display the sheet number on source destination arrows (Only #N), You can try setting the SHEET attribute to invisible and move the XREF attribute to display in center.