topic Re: Body Modifier on a corner and or intersection of two walls in AutoCAD Architecture Customization Forum

Body Modifier on a corner and or intersection of two walls

BCHRISTIANVMLQM — Wed, 02 Aug 2023 02:27:37 GMT

I am trying to put a column on the corner of two walls intersecting. I have tried many ways but no solutions. I have included a sample in PDF and DWG format of the condition I am trying to add the body modifier to, Any help would be appreciated. - Thanks Byron

Re: Body Modifier on a corner and or intersection of two walls

R_Tweed — Wed, 02 Aug 2023 18:26:23 GMT

It looked to me that the issue is with your wall components. The two walls are not cleaning up properly. To clean up the column cavity, I used a mass element with an interference condition. File is attached.

Re: Body Modifier on a corner and or intersection of two walls

R_Tweed — Thu, 10 Aug 2023 17:48:07 GMT

This might be off the original topic.. I see an interesting use of curtain walls and door styles for the creation of cabinets in your dwg. Did you come up with this internally or did you find a source somewhere? Now that I've seen this method, the multi-view casework symbols are dead to me.

Re: Body Modifier on a corner and or intersection of two walls

BCHRISTIANVMLQM — Thu, 10 Aug 2023 20:51:14 GMT

No I found a source, don’t make them before you checkout www.archidigm.com,

Byron

Re: Body Modifier on a corner and or intersection of two walls

R_Tweed — Thu, 10 Aug 2023 21:07:59 GMT

I thought as much, went to the site and did not get the impression they were using curtain walls. I will inquire.

Thanks!