topic Re: Unknown and Up to Date in Advance Steel Forum

Unknown and Up to Date

HarryHighpants — Thu, 23 Jul 2015 12:54:10 GMT

How can a drawing be 'unknown' and 'up to date' at the same time ?

Actually, what does 'unknown' even signify?

Re: Unknown and Up to Date

wtheron — Thu, 23 Jul 2015 13:17:08 GMT

Expand the selection tree to see which components on the drawing is unknown. It may be a view or a part number. Use this information to query the model and take it from there.

I have also previously encountered this, the solution is different everytime.

Re: Unknown and Up to Date

HarryHighpants — Fri, 24 Jul 2015 08:21:46 GMT

Ok, so I expand the node and it points to a BOM table which is empty.

I right click the table and update it.

The drawing still remains in the 'unknown' tree. What next?

Re: Unknown and Up to Date

wtheron — Fri, 24 Jul 2015 10:05:47 GMT

Hello Harry,

Can you try the following. From the document manager expand until you find the list again. Then right click to delete this object. Close the document manager and re-open. Check to see if it is still listed as unknown.

Re: Unknown and Up to Date

Anonymous — Fri, 24 Jul 2015 13:37:07 GMT

Please forgive me if this is a dumb question, but I noticed that the "Unknown" drawing title ends with "B-003.dwg" while the "Up to date" drawing title ends with "A-003.dwg". Are they actually the same drawing?

Re: Unknown and Up to Date

HarryHighpants — Fri, 24 Jul 2015 15:39:12 GMT

@Anonymous wrote:
Please forgive me if this is a dumb question, but I noticed that the "Unknown" drawing title ends with "B-003.dwg" while the "Up to date" drawing title ends with "A-003.dwg". Are they actually the same drawing?

You're right, I circled the wrong drawing. The correct drawing was further down the tree.

Re: Unknown and Up to Date

HarryHighpants — Fri, 24 Jul 2015 15:40:34 GMT

@wtheron wrote:
Hello Harry,

Can you try the following. From the document manager expand until you find the list again. Then right click to delete this object. Close the document manager and re-open. Check to see if it is still listed as unknown.

Yes, that fixes it.

AS sees an empty BOM and wants it out of the drawing.

Thanks

Re: Unknown and Up to Date

Anonymous — Fri, 24 Jul 2015 16:01:40 GMT

...and I should have read the whole list before posting!

Re: Unknown and Up to Date

Anonymous — Sat, 25 Jul 2015 04:49:07 GMT

So back to the start "Actually, what does 'unknown' even signify"

Happens often. This is scary because I worry that if I delete them the drawings will also delete.

Its as if they are not registered in the model when they are.

AS please advise

Re: Unknown and Up to Date

HarryHighpants — Sat, 25 Jul 2015 07:47:25 GMT

Dont delete the whole drawing, just expand the nodes and see what's the problem.

I almost made that same mistake, but wtheron put me on the right track with his post above.

Re: Unknown and Up to Date

Anonymous — Sat, 25 Jul 2015 23:21:44 GMT

Yes I see what is happening but wonderiny why ?

Don't believe this should occur under what seems to be normal conditions.

Don't have time to correct it either.