tema Multileader multiple leaders ads extra line weight en AutoCAD for Mac Forum

Multileader multiple leaders ads extra line weight

PaulMarsh8527 — Fri, 16 Jul 2021 21:01:08 GMT

I am using AutoCAD LT on the latest Mac mini and am having a problem with the leader line weight incrementally increasing as multiple leaders are added to to the multileader when all leaders are in the same plane.

I would like to see if it would be possible to only show a single leader line at 0.09 only.

Any assistance would be greatly appreciated.

screen shot multileader

screen shot for example, Line weight is shown as 0.09, line weight on. Fine next to the leader but thickens at the offset point and decreases thickness as each leader landing point drops off!

Regards Paul

Re: Multileader multiple leaders ads extra line weight

maxim_k — Sat, 17 Jul 2021 12:33:44 GMT

Hi Paul,

>>>>the leader line weight incrementally increasing as multiple leaders are added to to the multileader when all leaders are in the same plane.

It is just on-screen visual effect.

In fact line thickness does not change in the area where the leader lines overlap. You can check this by saving your drawing to PDF format.

And I think it is impossible to remove this on-screen visual effect.

Re: Multileader multiple leaders ads extra line weight

PaulMarsh8527 — Fri, 23 Jul 2021 06:36:00 GMT

Thanks there Maxim_K your dead right on the PDF print.

Cheers Paul