tema Re: Unable to select at points when zooming into details - after update en AutoCAD for Mac Forum

Unable to select at points when zooming into details - after update

kristinabhalter — Wed, 24 May 2017 17:41:09 GMT

Hello- I am having trouble after the update. I am unable to select points. The cursor jumps around the screen when I am zoomed in on a very small detail.

I have also crashed since the update.

I had been running smoothly with the same files yesterday before this update.

Re: Unable to select at points when zooming into details - after update

acadhelp1 — Wed, 24 May 2017 19:20:45 GMT

I'm not able to reproduce your issue with zooming with point selection.

I assume it was the AutoCAD 2017.1 update. Is that correct?

Re: Unable to select at points when zooming into details - after update

maxim_k — Wed, 24 May 2017 20:33:49 GMT

Hi

Please check if you have SNAP enabled - system variable
SNAPMODE should be equal 0 (zero) to turn off SNAP and allow to select points in any place in the drawing area.

You can also toggle SNAP on Status Bar or with F9 (Fn+F9) key, or with Cmd+B shortcut.

Maxim

Re: Unable to select at points when zooming into details - after update

Emmsleys — Fri, 26 May 2017 18:41:54 GMT

Hello @kristinabhalter,

Welcome to the Autodesk Community!

Following up on your thread, it appears that several folks have tried to help on this issue.

Did any of the posts in the thread help with your issue?

Please post back in the thread if you are still having an issue with AutoCAD or Select Accept as Solution for the post’s that helped.

Thanks for your time.

Happy Posting