https://forums.autodesk.com/t5/autocad-for-mac-forum/mac-only-plotting-half-the-page/m-p/5700968#M16117 Welcome to Autodesk Forums! <BR /><BR />HI,<BR />I think you need to find a way to correct plot settings inside your plotter software, I mean you need to change paper properties in the plotter dependent section of Print dialog.<BR /><BR />Maxim Wed, 01 Jul 2015 03:44:58 GMT maxim_k 2015-07-01T03:44:58Z https://forums.autodesk.com/t5/autocad-for-mac-forum/mac-only-plotting-half-the-page/m-p/5700658#M16114 <P>Last week, The bond in our plotter at work was switched to 24" from our normal 36". Since then autoCAD has only been plotting half of the page when i try to plot.</P><P>&nbsp;</P><P>Here is where it gets tricky.</P><P>&nbsp;</P><P>-What is printing is NOT running of the page, it stopping halfway across the sheet in a proportion that would make sense to what I am printing.</P><P>-In Page setup manager I have switched from ARCH D Landscape to ARCH D portrait.</P><P>-I have gone through my print settings and everything appears to be correct, I have printed in this format before manytimes, this seems to be an isolated incident.</P><P>-It is also doing this when I try to print PDF's at this size</P><P>&nbsp;</P><P>Does anyone have any thoughts?</P><P>Is there any useful&nbsp;information I may have left out?</P><P>&nbsp;</P><P>Thank you.</P> Tue, 30 Jun 2015 20:47:44 GMT https://forums.autodesk.com/t5/autocad-for-mac-forum/mac-only-plotting-half-the-page/m-p/5700658#M16114 Anonymous 2015-06-30T20:47:44Z https://forums.autodesk.com/t5/autocad-for-mac-forum/mac-only-plotting-half-the-page/m-p/5700968#M16117 Welcome to Autodesk Forums! <BR /><BR />HI,<BR />I think you need to find a way to correct plot settings inside your plotter software, I mean you need to change paper properties in the plotter dependent section of Print dialog.<BR /><BR />Maxim Wed, 01 Jul 2015 03:44:58 GMT https://forums.autodesk.com/t5/autocad-for-mac-forum/mac-only-plotting-half-the-page/m-p/5700968#M16117 maxim_k 2015-07-01T03:44:58Z