<?xml version="1.0" encoding="UTF-8"?>
<rss xmlns:content="http://purl.org/rss/1.0/modules/content/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:rdf="http://www.w3.org/1999/02/22-rdf-syntax-ns#" xmlns:taxo="http://purl.org/rss/1.0/modules/taxonomy/" version="2.0">
  <channel>
    <title>tema Re: Face groove en FeatureCAM Forum</title>
    <link>https://forums.autodesk.com/t5/featurecam-forum/face-groove/m-p/8682130#M4403</link>
    <description>&lt;P&gt;Found out that if you tick the skip wall pass on the turning properties page than it will not plunge through the component, no idea as to why it want to do the wall pass when in the middle of a roughing cycle&lt;/P&gt;</description>
    <pubDate>Mon, 25 Mar 2019 17:34:54 GMT</pubDate>
    <dc:creator>brian_p1</dc:creator>
    <dc:date>2019-03-25T17:34:54Z</dc:date>
    <item>
      <title>Face groove</title>
      <link>https://forums.autodesk.com/t5/featurecam-forum/face-groove/m-p/8675577#M4398</link>
      <description>&lt;P&gt;Have been trying to program this face groove using the face turn feature works up until the point of it plunging into the stock full depth around the curve then retracting back to carry on the roughing.......no idea why it would want to do this, any ideas?&lt;/P&gt;
&lt;P&gt;Have also tried as a groove from curve but it doesn't like that either&lt;/P&gt;</description>
      <pubDate>Thu, 21 Mar 2019 20:20:18 GMT</pubDate>
      <guid>https://forums.autodesk.com/t5/featurecam-forum/face-groove/m-p/8675577#M4398</guid>
      <dc:creator>brian_p1</dc:creator>
      <dc:date>2019-03-21T20:20:18Z</dc:date>
    </item>
    <item>
      <title>Re: Face groove</title>
      <link>https://forums.autodesk.com/t5/featurecam-forum/face-groove/m-p/8682130#M4403</link>
      <description>&lt;P&gt;Found out that if you tick the skip wall pass on the turning properties page than it will not plunge through the component, no idea as to why it want to do the wall pass when in the middle of a roughing cycle&lt;/P&gt;</description>
      <pubDate>Mon, 25 Mar 2019 17:34:54 GMT</pubDate>
      <guid>https://forums.autodesk.com/t5/featurecam-forum/face-groove/m-p/8682130#M4403</guid>
      <dc:creator>brian_p1</dc:creator>
      <dc:date>2019-03-25T17:34:54Z</dc:date>
    </item>
  </channel>
</rss>

