topic Low Pressure Round Duct Not Adding Short Pieces in Fabrication CADmep Forum https://forums.autodesk.com/t5/fabrication-cadmep-forum/low-pressure-round-duct-not-adding-short-pieces/m-p/5975661#M949 <P>When I am drawings with low pressure round duct (snaplock pipe/smoke pipe), I am getting a gap between the last standard piece of duct and the elbow or transition meaning that it is not adding a piece of short duct in between them. &nbsp;Any advice will be appreciated.</P> Wed, 06 Jan 2016 14:58:53 GMT Anonymous 2016-01-06T14:58:53Z Low Pressure Round Duct Not Adding Short Pieces https://forums.autodesk.com/t5/fabrication-cadmep-forum/low-pressure-round-duct-not-adding-short-pieces/m-p/5975661#M949 <P>When I am drawings with low pressure round duct (snaplock pipe/smoke pipe), I am getting a gap between the last standard piece of duct and the elbow or transition meaning that it is not adding a piece of short duct in between them. &nbsp;Any advice will be appreciated.</P> Wed, 06 Jan 2016 14:58:53 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/low-pressure-round-duct-not-adding-short-pieces/m-p/5975661#M949 Anonymous 2016-01-06T14:58:53Z