https://forums.autodesk.com/t5/fabrication-cadmep-forum/design-line-slope/m-p/11157514#M5037 <P>Hello everyone, i have been using fabrication&nbsp; CADmep for a while now and the define source was working perfectly. but now the slope is in reverse for any horizontal piping. the only way i have been able to work with it is to do slope as a negative value. The only think that happen is my service map got corrupted so i had to replace it and that is when this has changed.</P> Mon, 09 May 2022 18:31:23 GMT Alpadex 2022-05-09T18:31:23Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/design-line-slope/m-p/11157514#M5037 <P>Hello everyone, i have been using fabrication&nbsp; CADmep for a while now and the define source was working perfectly. but now the slope is in reverse for any horizontal piping. the only way i have been able to work with it is to do slope as a negative value. The only think that happen is my service map got corrupted so i had to replace it and that is when this has changed.</P> Mon, 09 May 2022 18:31:23 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/design-line-slope/m-p/11157514#M5037 Alpadex 2022-05-09T18:31:23Z