Fabrication CADMEP Section issue

rajadeva93 — Mon, 24 Jan 2022 07:19:01 GMT

Hi, I have created a section with elevation datum of 50' and soffit of 60' when placing pipe its created on 0' elevation(if my z value is 0' it should be @ 50' right? because of elevation datum) and hanger Rods starts from 60'. Is this suppose to work like this(revit user new to Fabrication CADMEP).

Re: Fabrication CADMEP Section issue

MOatman — Mon, 24 Jan 2022 13:26:20 GMT

The elevation datum is an imaginary floor. Fabrication parts will reference that imaginary floor when reporting their elevation.

So, if you set the datum to 50'-0" and draw the pipe at 0'-0" then the pipe would report its elevation at -50'-0".

The pipe is located 50'-0" BELOW the imaginary floor.

If you draw the pipe at 55'-0" then the pipe would report its elevation at 5'-0".

topic Fabrication CADMEP Section issue in Fabrication CADmep Forum

Fabrication CADMEP Section issue

Re: Fabrication CADMEP Section issue