https://forums.autodesk.com/t5/fabrication-cadmep-forum/selecting-hangers-based-on-distance-from-soffit-and-not-pipe/m-p/9530306#M4519 <P><SPAN>We run into issues a lot in tight ceiling spaces where our ceiling pipe needs to be so close to the soffit elevation of the slab that a standard tear drop or clevis hanger will not fit in the space and we have to use a "stirrup" style hanger with half of a riser clamp and two drop rods. I've built this item from CID 1239 and I want it to populate automatically when a sloped system breaches that threshold elevation where regular hangers will no longer fit.</SPAN><BR /><BR /><SPAN>Is there a Condition or support spec that can be setup to allow the software to do this? Right now all I can do is control hanger types by pipe sizes...</SPAN><BR /><BR /><BR /></P> Wed, 20 May 2020 20:02:38 GMT ZTR88 2020-05-20T20:02:38Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/selecting-hangers-based-on-distance-from-soffit-and-not-pipe/m-p/9530306#M4519 <P><SPAN>We run into issues a lot in tight ceiling spaces where our ceiling pipe needs to be so close to the soffit elevation of the slab that a standard tear drop or clevis hanger will not fit in the space and we have to use a "stirrup" style hanger with half of a riser clamp and two drop rods. I've built this item from CID 1239 and I want it to populate automatically when a sloped system breaches that threshold elevation where regular hangers will no longer fit.</SPAN><BR /><BR /><SPAN>Is there a Condition or support spec that can be setup to allow the software to do this? Right now all I can do is control hanger types by pipe sizes...</SPAN><BR /><BR /><BR /></P> Wed, 20 May 2020 20:02:38 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/selecting-hangers-based-on-distance-from-soffit-and-not-pipe/m-p/9530306#M4519 ZTR88 2020-05-20T20:02:38Z