topic camduct 2021 in Fabrication CADmep Forum https://forums.autodesk.com/t5/fabrication-cadmep-forum/camduct-2021/m-p/9481337#M4483 <P>Hi,</P><P>i have installed a new trial version of camduct 2021 to see if i can use it.</P><P>apart from all the other issues ive had to get this far i am finally at my wits end.</P><P>if i use the default material size sheet it nests ok</P><P>if i copy the default material size and then edit them to the alternate size sheet i use all goes to hell.</P><P>the nests 'look' like they are nested in the bottom left corner of the sheet ok but........</P><P>when i load them into my dynatorch table the cutting is started about 600mm in x and 200 mm in y ... then the nested job.</P><P>It basically adds a x and y value to move everything right and up before it starts the cut...</P><P>&nbsp;</P><P>How the hell can i stop that...</P><P>even using the default material sheet size and resizing the sheet doesn't help...</P><P>&nbsp;</P><P>regards,</P><P>Bill</P> Thu, 30 Apr 2020 00:40:01 GMT Anonymous 2020-04-30T00:40:01Z camduct 2021 https://forums.autodesk.com/t5/fabrication-cadmep-forum/camduct-2021/m-p/9481337#M4483 <P>Hi,</P><P>i have installed a new trial version of camduct 2021 to see if i can use it.</P><P>apart from all the other issues ive had to get this far i am finally at my wits end.</P><P>if i use the default material size sheet it nests ok</P><P>if i copy the default material size and then edit them to the alternate size sheet i use all goes to hell.</P><P>the nests 'look' like they are nested in the bottom left corner of the sheet ok but........</P><P>when i load them into my dynatorch table the cutting is started about 600mm in x and 200 mm in y ... then the nested job.</P><P>It basically adds a x and y value to move everything right and up before it starts the cut...</P><P>&nbsp;</P><P>How the hell can i stop that...</P><P>even using the default material sheet size and resizing the sheet doesn't help...</P><P>&nbsp;</P><P>regards,</P><P>Bill</P> Thu, 30 Apr 2020 00:40:01 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/camduct-2021/m-p/9481337#M4483 Anonymous 2020-04-30T00:40:01Z